How Should The Press Be Used And Maintained?

First, open

Power, start the machine, adjust the distance between the press bar and the other parts, and adjust the other departments according to their needs.

Two. Select the corresponding gear of the required action switch.

Three, put the shoes on the rubber pad, and put the pad in accordance with the corresponding arc, all the adjustment can be operated.

Four, press the manual button, the pressure bar moves across, the big seat rises, each part moves in order, the pressing time is: 8-10S.

Five. When the time is over, the machine is restored, the shoes are checked, and the machine is adjusted as needed.

Compaction, not empty, not super line, not degumming;

Six, matters needing attention: cleaning the oil tank and antirust oil.

Open the fuel tank cover, add hydraulic fluid (China Petroleum Corp R-68#) about 100 kilograms, and keep the hydraulic oil clean. The oil surface should be higher than the oil filter cylinder 30mm, which is lower than the oil tank surface 30mm.

The hydraulic oil of the new fuel tank should be replaced after 800 hours.

After every 2800 hours of work, replace the hydraulic oil to ensure the normal operation of the machine. Connect the power supply (300V, 50HZ) and pay attention to the protection of the grounding wire to ensure safety, turn on the power supply, start the motor, the total pressure of the pressure gauge is 30kg/cm ~50kg/cm, and the pressure must be the same.

If the pressure is reversed, the motor can only be replaced by a two phase power supply. The motor runs ahead of time for 5 minutes, so that the oil temperature reaches 10 degrees C (50F).

How to maintain the press?

1. turn off the power supply after use.

2. strictly prohibit empty machine operation, so as not to damage the machine.

3. keep the machine clean, and clean the machine outside the machine every day after work. Note that it is not possible to use the corrosive volume of gasoline and toluene to erode it, so as not to damage the machine.

4., attention should be paid to cleaning the electrical appliances box and placing litter and conductor strictly.

5. regularly check the slideway and movement parts of the pressure bar, and timely add and replace lubricating oil to ensure lubrication.

6. replace 68# cycle hydraulic oil once a year to ensure that the oil temperature does not increase and the machine life is prolonged.

7. if the machine leaks oil and leaks oil, it should notify machine repair.

8. guarantee

The door cover is complete, fastening parts of each part of the machine, strictly implementing the operation rules, checking and troubleshooting in time.

Matters needing attention during operation:

1. before going to work, check whether the lubricating oil in the sliding part is good, whether there is leakage or screw loosening, and ensure that the machine is clean.

2. the operation should be carried out in a correct way, especially after the positioning of the last position, the head and hand should immediately leave the press and the pressure bar to ensure safety.

3. when the press is raised, it is forbidden to touch the last part by hand or any appliance. If there is any improper adjustment, please press the brake switch immediately and adjust it again after the action is restored, so as to avoid injury or damage to the machine.

4., when the pump pressure is adjusted, the pressure on the left and right sides will remain the same (observe the oil pressure gauge), otherwise the motor and pump will be damaged.

5. strictly prohibit the operation of empty machine. This machine only allows one person to operate, do not operate with the same pressure seat two people, so as to prevent accidents.

During maintenance, neither the operator nor any other person can start the power supply operation machine.