What Are All Kinds Of Shoe Machine Items And Operation Standards?

All kinds of shoe machine items and operation standards:

One

Check the power switch, put the mold in the middle of the bottom, fix the left and right position, press the on green key switch first, right foot step on the foot switch again, press the red key to indicate the boot, then give the machine routine maintenance.

2. cut the middle bottom, the big bottom machine: adjust the distance between the cutter and the backboard according to the different numbers, adjust the length of the backboard, and the width of the bottom end is short and narrow.

Turn green in the direction of on and turn off in the direction of off, and record daily maintenance and regular maintenance.

3. nailed machine: first add the necessary anchor to inspect the belt switch and the power supply department.

Fixing the location of the nail in the middle of the seven character iron bar with different SIZE, press the green switch and pedal on the foot switch, and press the red to turn off the machine for daily maintenance.

Four

Check the switch power supply, fix the movable ruler of different SIZE, tighten the iron plate of the bottom and upper bottom movable disc and the fixed bottom die. According to the machine plane green switch, the time and pressure are 5 seconds and 18 kilograms respectively. The safety runaway device should be checked at any time, and the switch is switched on by red switch for daily and regular maintenance.

5. grinding machine: the sand cloth stuck to the rubber wheel must be fastened. When the machine is installed, the screws are tightened, the vacuum cleaner and the power switch are checked, the green switch is switched on in the on direction, and the machine is turned off to off direction for routine maintenance.

Six

Check the vacuum cleaner, the power switch and the belt. When you change the knife, gently pull the belt with your hand. The knife can't touch the following push wheel. Look at the distance from the bottom adjustment knife to the on direction, turn off the machine to off direction, and do routine maintenance.

7. press machine: check the power switch, the general pressure is about 20 kg, the time is 5~6 seconds, fixed standard press die, press the green key to twist, use foot pedal switch, turn off press the red key, make daily and regular maintenance.

8. sawing machine: connect the strong saw blade, first install the upper flywheel, then install the lower wheel, turn the upper wheel lightly with the hand, adjust the tightness, and check the switch on the safety well, then switch on the air switch, switch off the switch, and do the routine maintenance.

9. grinding platform: check the switch, vacuum cleaner, grinding wheel is damaged, the gasket should be leveled, then the grinding wheel is screwed on the screw gasket, if necessary, the sound is not correct. Immediately, wrap the paper on the center shaft to prevent the wheel from shaking. Press green to turn on the machine and turn it off for maintenance.