Brief Introduction Of "Test Method For Dry Heat Dimensional Change Of Hot Melt Adhesive Lining"

The FZ/T 01082-2009 "test method of hot and dry size change for hot melt adhesive lining" drafted by many units of Shanghai clothing research institute has been approved by People's Republic of China Ministry of industry and information technology and implemented since June 1, 2010. The standard specifies the size change of the hot melt adhesive lining after heat treatment. test method 。 The standard applies to all kinds of materials. Woven The determination of dry heat dimensional changes of knitted fabrics and nonwoven fabrics made of hot melt adhesives and bonded fabrics.

this standard The main contents include normative reference documents, principles, equipment and appliances, sample preparation, operation procedures, result calculation, and test reports.

This standard replaces FZ/T01082-2000 "determination of dry heat dimensional change of hot melt adhesive interlining for clothing". Compared with the previous edition standards, the following main contents have been amended.

1. Change the standard name to "dry hot dimensional change test method for hot melt adhesive lining".

2, the pressing equipment has been adjusted.

3, adjust the contents of the fourth and fifth chapters of the previous edition.

4, change the "dry heat dimension" in the previous edition to "dry heat dimension change rate".

The previous versions of this standard replace the standard: GB/T11400-1989, FZ/T01082-1999, FZ/T01082-2000.