How To Improve The Efficiency Of Embroidery Machine For Garment Machinery

< p > how to guarantee the efficient work of < a target= "_blank" href= "http://www.91se91.com/" > clothing /a > mechanical embroidery machine? The following articles will be realized through 10 basic operations and requirements. We sorted out some common problems in the operation of embroidery machines for reference: < /p >
< p > (1) when all pins are in high position, they cannot rotate the dial with their hands; < /p >
< p > (2) the pipe can not be moved at high position, otherwise it will easily die; < /p >
< p > (3) do a good job in the preparation of the pull rod before driving, wear the bottom line, choose the a href= "http://www.91se91.com/news/index_c.asp" > embroidery > /a > pattern, choose a good matching pattern and appropriate embroidery parameters; < /p >
< p > (4) before pulling, all the pins should be checked down. If there is no need to manually drop all the pins first and then pull the lever to drive, it will easily cause damage or leak to the machine. < /p >
< p > (5) when gold is embroidered, the switch of the gold device should be placed on the upper part, otherwise the gold device will not automatically rise or fall; < /p >
< p > (6) the pressure of the gold tablet device is suitable, too small to lift automatically, and it is too big to damage the gold device. Do not move freely when the air pressure is adjusted; < /p >
< p > (7) every time when making the new three in one combination pattern, after setting up the embroidery point, the border check shall be made first, so as not to change the frame between the left and right handpieces, and to damage the gold tablet device or the machine head; < /p >
< p > (8) when the belt embroidery and sawtooth embroidery are embroidered, the surface line and the sawtooth core line of all the heads should be loosed first. At the same time, all the pins should be raised to high position, and the manipulator should be placed in a working state before reversing. Otherwise, there may be tear a target= "_blank" href= "http://www.91se91.com/" > cloth < /a >. After the embroidery is finished, first arrange the dribbling (or saw tooth core) on all the wire wheels, put the pins down, install the manipulator into the working position, and then pull the lever to drive; < /p >
< p > (9) when embroidering embroidered pieces, press the embroidered function key, then all the cloth clips should be loosened before moving the embroidery frame, otherwise it will tear the cloth easily. When changing the frame, the cloth in front is clamped. Press the key to move the pin and pin away from the cloth, and then clip the cloth clip on the back, so that the cloth is relatively smooth; < /p >
< p > (10) every time after the embroidery is finished, all the cloth clips must be placed on the two corners in front of the platen, and can not be placed behind the rack or behind the platen, so as to prevent the cloth from falling on the cloth or falling into the gap of the connecting board of the platen, causing damage to the cloth or < a href= "http:// www.91se91.com/news/index_c.asp" > machine < /a >. < /p >