How To Handle The Last Stage In The Development Of Paperboard

The material for last sticking is adhesive tape, pparent paper and kraft paper.

Weigh the pros and cons. The use of kraft paper is more common. The straight direction of the paper fiber is straight forward to the shoe last. The length is slightly longer than that of the shoe last, and the width is slightly higher than the center line width of the last.

You can knead the paper and do not need to rub it, otherwise it will be able to last, but it is difficult to uncover and easy to distort.

After rubbing, the paper is flattened, and the paper and the last surface are respectively rubbed and dried.

1. the whole last sticker method is not symmetrical when it is inserted into the surface.

First, cut the 2/3 according to the center line of the sticker, then place the center line of the sticker on the front line of the shoe last, and paste it on the last surface.

Two to three tiny scissors are placed in the concave part of the last, so that the last surface is smooth.

2. semi semi surface sticker is used for the inside and outside of the upper and outside.

The method is to cut out a paper slightly longer than the shoe last, tie it on the outside side of the shoe last, and cut three cuts on the concave part of the last, then take a small piece of sticker to fill the three gaps.

3. full head and empty waist sticker method is used for sandals to cover the last surface. Generally, two pieces of paper are cut according to the length of the front and the rear wing, and the size of the surface is slightly higher than that of some posts, such as the deep cut in the most concave part.

4. empty space and full waist sticker method is used for female sandals to paste on the surface. Cut out a piece of paper with a length slightly shorter than the last length of 1cm, place the center line of the paper on the center line of the shoe last, and paste it into the inside and outer ring of the last. If the head is empty, 1cm can be left, and the lower part of the rear part can be cut off to make it more acceptable.