Design Of Three Quarter Footwear -- Making Sample Template

The main points and methods of making scribing boards are the same, see figure 1-3-10.

 

As shown in the figure, the marking board is made according to figure 1-3-9, and there is a notch at the bottom of the front Baotou, which indicates the treatment of the bottom handle.

There is a notch on the back of the back without a cut. The front contour line represents the Huai line, and the rear contour line represents the outer line. The two lines must be used before and after the manufacture, and the gap at the bottom indicates that there is a difference in the location of the ends between the inside and outside.

The shoe has a triangular notch. The upper end of the shoe represents the outer shoe line. The shoe line of the shoe is the outline of the outer layer.

The basic template includes the front Baotou, the front middle, the back, the tongue, and the insurance skin.

Mark the rules on the basic template.

The basic way to make basic templates is to follow the diagram, see figure 1- 3-11.

 

Use the basic template to make the opening material template, and do not ask for rules on the opening template. But the quantity of processing required is shown in figure 1-3-12.